Making a Liquid Wrench Better Than WD-40
I think a lot of people have had those nasty cases where bolts break, especially in very awkward places, it’s one thing when the bolts are small, you can just snap it off and replace it, but another thing when the bolt is big enough and here comes the help of extra compound or grease to make the nuts unscrew as easy as possible.
I tried a lot of penetrating greases and didn’t get the expected effect, they were all very similar to each other, only slightly softened the rust, but the nuts were unscrewed all the same or very tight, or the bolts broke off. So I decided to make my own penetrating grease, which will be superior to the purchase, so the first option will be suitable only for unscrewing, or separation of severely rusted parts.
We’re gonna need;
a container like a small cup, pour a little less than half of white spirit, then we need some dry grease, no matter what kind, it can be boron nitride, then we need some dry grease, no matter what kind, it can be boron nitride, graphite, molybdenum, but I used dry grease “forum” (read about it on the Internet) but I used dry grease “forum” (you can read about it on the Internet)
Pour about half a teaspoon of dry grease “forum”, stir it and add any converter rust can the cheapest, somewhere around 50/50 with white spirit.
Then again stir it, by the way before every use such grease has to be shaken or shaken.
That’s our liquid wrench is ready. 1 variant
Try to do it, it unscrews everything, even what can not cope with common VD-40.
The second option; we need the solvent, as you see I have it 650, that was left, then the engine oil preferably take the synthetic and grease, you can take a simple graphite grease, I used the so-called “Zelenka”.
In our cup put a syringe of green or any other grease, then pour a half-cup solvent, we need the solvent so that the consistency was more fluid, respectively it will have more penetrating ability. then pour a half-cup solvent, we need the solvent so that the consistency was more fluid, respectively it will have more penetrating ability. When the “green” will be dissolved, then we pour two caps of synthetics and again mix everything well.
Enter your email and get emails with new crafts.
This grease has such a trick, when we apply it, the liquid quickly penetrates into all places, then the solvent almost immediately volatilizes and only lubricants remain, a powerful friction modifier.
Well, here we are ready for the second option, but I must say at once I liked the first option better. But to each his own, I hope the article was helpful to someone.
